911 Carrera Cabriolet (996) - Keyless Entry Range Improvement - Technical Service Bulletin
Beginning from below, secure the wire harness (Figure 6, inset) to the A-pillar on the outside of the protective sleeve (Item C) using the adhesive
strips (Item B), so that the antenna (Item D) points in the direction of vehicle interior.
This installation position of the wire harness will prevent the antenna lead from coming into contact with the unpainted bodyshell and becoming
shielded.
10.
Install trim panel for left A-pillar.
11.
Check function and range of the remote control.
Working Time
References:
POSES, Workshop Manual, 911 Carrera (996):
>
Group 7: 70 57 19 Removing and installing trim panel of A, B and C pillars
>
Group 7: 70 57 19 - Removing and installing A-pillar trim panel - Cabriolet
Disclaimer