911 Carrera Cabriolet (996) F6-3.4L (1999)
2. Coat the cloth covering with adhesive and stick it inside around the corner bow -inset A-.
3
-
Fastening holding strap of the convertible-top covering
1. Position holding strap at the right on convertible-top frame 3 on the inside and press in the clip.
On the left side, the holding strap is fastened with the fastening clip of the wiring harness.
4
-
Fastening the fastening strap at the main bow
1. Turn the vertical fastening strap of the convertible-top covering inward around the main bow, and place it on the shaped sheetmetal part.
Screw in with the oval-head screws -B- T15 M3.5.
Tightening torque 1.7 Nm (1 ftlb.)
1. Position wedge on the main bow and screw in place with the fastening screws T25 M5 -A-
Tightening torque 2.8 Nm (2 ftlb.)
5
-
Fastening the convertible-top covering at the sides of the roof frame 1
1. Lay the convertible-top covering to the front and guide the shaped sheetmetal part -14- into the roof frame -15- from above.
2. Fasten the convertible-top covering with the fastening screws -13- starting from the rear bottom side of the roof frame.
Tightening torque 5 Nm (4 ftlb.)