911 Carrera Cabriolet (996) F6-3.4L (1999)
![background image](/porsche/911_carrera_cabriolet_(996)/f6-3.4l/Page-1016007.png)
Note!
The grommet -3-is not replaced!
7.
Undo brake pushrod -9- on the brake pedal and remove.
Note!
The former brake pushrod -9- with guide (double rib) -arrow- is to be replaced with the brake pushrod -9.1- without guide!
Fitting
Caution!
Material damage to the connection to the brake pedal if the tightening torque used on the connecting pin is too great!
^
It is essential to observe the specified tightening torque on the connection thread bushing/pin.
1.
Install new brake pushrod -9.1-. Tighten the threaded bushing -arrow- of the pin to 10 Nm (7.5 ft-lb.) (Please observe)!
2.
Insert seal -7.2- (without lubricant) into the firewall. It is essential to ensure correct seating! Then insert (push in) the connection sleeve -7.1- into
the seal -7.2- using rubber sliding compound for example Capella or tyre mounting paste. Recheck that it is seated correctly and correct if
necessary!
3.
Mount seal -7.3- and coat with Capella or tyre mounting paste.