911 Carrera Cabriolet (996) F6-3.4L (1999)
8.
Tighten fastening screws of brake booster (Torx T 45) -arrow- to 23 Nm (17 ft-lb.). Fit the vacuum line for the brake booster.
-
If the brake master cylinder has been removed, tighten the fastening nuts (M14) to 49 Nm (36 ft-lb.).
9.
Connect the 2 push rods. To do so, mount the fastening nuts -arrow-.
Note!
^
Adjusting the brake pushrod length changes the position of the brake pedal.
^
Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given!
^
After the brake pushrod is adjusted, check the brake light switch adjustment!
10.
Check the position of the brake pedal -Dimension X 45 + 5 mm- Perform measurement between the centre of the brake pedal plate and the
accelerator. Perform a fine adjustment of the brake pushrod if the correct position of the brake pedal is not given.
-
Precise adjustment of brake pushrods: Undo the lock nut for this purpose and the turn the push rod accordingly at the hexagon -arrow- until
-dimension X 45 + 5 mm- has been achieved. Subsequently re-tighten the the lock nut.