911 Carrera Cabriolet (997) F6-3.6L (2007)
process.
Operating instructions:
Always use the garage door opener in the direction of travel. Otherwise range limitations cannot be ruled out.
Before selling the vehicle, erase the programmed garage door opener signals on the keypad.
To determine whether the original remote control has a fixed or variable code, please read the instructions for the original remote control.
In the case of a standard fixed code, the LED in the roof console is permanently lit during the transmission process. No further steps are necessary for the
operation of compatible systems.
If the system set is not activated by the garage door opener control unit, this may be because the original remote control has a variable code.
Assigning garage door opener/HomeLink signals to buttons
Garage door opener/HomeLink with fixed code system
INFORMATION:
-
This operation erases the standard codes set in the factory. Do not repeat this operation if additional buttons are to be programmed.
-
Hold the two outer buttons -1 and 3- down for around 20 seconds until the LED -A- starts to flash quickly. All programmed signals for the buttons
-1 to 3- are erased.
1. Press the required button until the LED flashes slowly. You then have around 5 minutes to complete steps 2 and 3.