911 Carrera Cabriolet (997) F6-3.6L (2007)
NOTE: When sliding in the underbody trim panel, make sure the overlap is correct.
1. Position brake air duct -5- on the transverse strut and secure with the fastening screw -2-.
Tightening torque: 2 Nm (1.5 ftlb.)
2. Insert cover for underbody -4- and engage it at the two brake air ducts -5- at the rear.
3. Tighten fastening screws -2-.
Tightening torque: 2 Nm (1.5 ftlb.)
NOTE: Fastening nuts cannot be used again following removal.