911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-928009.png)
4.3. Lift tension strap -3- and cover -4- slightly -arrows B- and pull wiring harness -5- carefully out of the roof frame -arrow C-.
5. Rework wiring harness.
5.1. Wind boot -1- between the fixing clips -2- on the wiring harness -3- so that the opening edge of the boot is on the side of the fixing clips.
5.2. Wind Teflon tape -4- once around the fixing clips -2-, then four times around the boot, overlapping the tape by half its width.
5.3. Press Teflon tape -4- down firmly.
NOTE: Check protective tube is positioned correctly:
-
The protective tube must lie between the fixing clips.
-
Do not cover fixing clips.
-
Opening edge of protective tube and fixing clip must point in the same direction.
6. Secure wiring harness.
6.1. Lift tension strap -3- and cover -4- slightly -arrows A- and insert wiring harness -5- into the roof frame -arrow B-.
6.2. Engage clip -1- at the fixing clip -2- (-arrow C-).
6.3. Press in wiring harness -2- at the roof frame -3- (-arrows A-) until the fixing clips -1- engage -arrows B-.