911 Carrera Cabriolet (997) F6-3.6L (2007)
NOTE: Seal for convertible-top tip must not be trapped. There must be no gap between seal and covering, and the seal with the covering
must run evenly. If necessary, pull the seal up and out and tap it in again.
3.5. Slide the buffer -3- onto the middle of the cover strip. Position cover strip -2- on the roof frame -4- and screw down using the fastening
screws -1- (-arrow-). -] Tightening torque: 3.5 Nm (2.5 ftlb.)
4. End hood service position. Refer to Hood service position