911 Carrera Cabriolet (997) F6-3.6L (2007)
NOTE: Sealing surfaces must be clean and free of grease.
1. Remove protective paper -2- and stick new foam pads -1- at the marked positions.
2. Position upper part of lid lock -1- on hood compartment lid.
3. Tighten fastening screws -2-. -] Tightening torque: 10 Nm (7.5 ftlb.)
4. Screw in rubber buffer -1- in -direction of arrow-.
5. Fit edge protection -2- on hood compartment lid -3- (-arrow A-).
NOTE: When installing the second retaining clip (on right/left), make sure that it is fitted at a distance of -X = 450 mm- from the end of the edge
protection.