911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-937008.png)
To open, insert the Allen key -A- through the bore -X- of the roll-over bar module into the hydraulic valve -B- and turn approx. 1 turn to the left.
To close, insert the Allen key -A- through the bore of the roll-over bar module -X- into the hydraulic valve -B- and turn to the right.
Bleeding the hydraulic system
CAUTION: Damage to the convertible-top frame if not running synchronously.
-
Bleed the hydraulic system only after the hydraulic cylinders have been removed from the convertible-top supports and drive levers on
the left and right.
-
The system has a self-bleeding feature. Three to four operations will bleed the system. After bleeding, check the oil level in the container on the
hydraulic pump and check if necessary.
To bleed, the hydraulic valve must be closed.
Subsequent work
1. Calibrate convertible top. Refer to K2 -Calibrating convertible top in cabriolet
2. Install trim panel for convertible top rest. Refer to Removing and installing trim panel for convertible top rest
3. Install rear wall trim panel Refer to Removing and installing trim panel for rear wall
4. Install rear side trim panel. Refer to Removing and installing rear side trim panel
