911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-541003.png)
WM 463420 -PCCB Removing and installing front brake pads
Information on PCCB brake pads
Since the production launch, Pagid-P40-2 brake pads with -brake-piston damping plates- have been fitted on the front axle for PCCB brakes.
With the introduction of modified brake pads - Pagid P40-3 - the brake-piston damping plates are no longer used. Refer to the Parts Catalogue for
details of use/allocation.
Preliminary work
Remove wheel.
Removing front brake pads - PCCB brakes
The core of the warning contact wire must not be left exposed. Worn insulation is not important.
If necessary, remove a little brake fluid from the reservoir by suction in order to prevent an overflow when the disc brake pads are pushed back!
1. Remove fastening screw at the retaining pin. Then screw the M8 auxiliary screw into the retaining pin. Hold down the expanding spring with a
screwdriver and remove retaining pin.