911 Carrera Cabriolet (997) F6-3.6L (2007)
Installing coolant regulator
Installing coolant regulator
1. Clean the sealing faces of the housing and crankcase.
2. Insert thermostat insert into guide using the assembly aid P 9627.
3. Position housing cover with new seal and thermostat on crankcase and position with four M6 fastening screws.
4. Tighten the screws. -> Tightening torque: 10 Nm (7.5 ftlb.)
Note: To facilitate assembly of coolant pipes and hoses, smear with Kluber Syntheso Glep or alternatively Kluberplus S06-100 assembly gel
(available in the Porsche Parts Catalogue).
5. Fit coolant hoses.
6. Secure coolant line on crankcase. Tighten two M6 screws. -> Tightening torque: 10 Nm (7.5 ftlb.)
Subsequent work
Subsequent work
Warning: Coolant is hazardous to health.
^
Risk of skin irritation.
-> Wear protective gloves and goggles.
-> In the event of contact with the skin or eyes, wash immediately with plenty of water.
1. Fill coolant and bleed system.
2. Perform a test drive, adjusting the coolant level in the container if necessary (note minimum/maximum marking).