911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-214005.png)
5. Push cable plug onto the hydraulic valve. Make sure that the plug engages audibly.
6. Fit the side shield to the relevant side of the engine. To do this, insert and tighten the two M6 x 16 Torx screws -arrows-. -> Tightening torque: 7.5
ftlb.
Note: The clamp between the rear silencer and the catalytic converter must be replaced.
7. On cylinder side 4 - 6, fit the holder for the rear silencer and re-install the rear silencer. -> Tightening torque: 17 ftlb.; -> Tightening torque: 17
ftlb.; -> Tightening torque: 33 ftlb.; -> Tightening torque: 17 ftlb.; -> Tightening torque: 22 ftlb.
