911 Carrera Cabriolet (997) F6-3.6L (2007)
bearing shells in gear carrier half 4-6 point towards the dowel sleeve side, the fixing lugs of the bearing shells in gear carrier half 1-3 face the
opposite side.
Twist lock of bearing shell
6. Insert crankshaft. Check that the thrust washers are seated properly
7. Carefully position gear carrier half 1-3 on the crankshaft and gear carrier half 4-6. Fix the gear carrier halves by tapping them carefully with a
plastic hammer.
8. Position 14 M9 x 127 thrust-bearing screws manually. Pre-tighten screws to the required tightening torque in accordance with the tightening
sequence. Then tighten to the required torque angle. -> Initial tightening: 15 Nm (11 ftlb.); -> Torque angle: 120°