911 Carrera Cabriolet (997) F6-3.6L (2007)
3. Unscrew the fastening nut -2- for the refrigerant line condenser-fluid tank in front of the fluid tank, detach the line from the holder and pull out
from under the water hoses for the heat exchanger.
Installing the condenser-fluid tank line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
1. Lay the refrigerant line under the heat exchanger hoses and screw down on line to fluid tank -2- with fastening nut. Tightening torque: 20 Nm (15
ftlb.)
2. Clip line into the holder.
3. Position holder for refrigerant lines and secure with the fastening nut -1-. Tightening torque: 6 Nm (4.5 ftlb.)
Subsequent work
Subsequent work line condenser-fluid tank
Installing battery.
Filling in refrigerant.
Installing cowl panel cover.
Removing and Installing Condenser-Condenser Line
Removing And Installing Condenser-Condenser Line