911 Carrera Cabriolet (997) F6-3.6L (2007)
Removing compressor/evaporator line
INFORMATION:
-
Close off all lines and connections using suitable plugs during removal.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
1. Unscrew the fastening screw -1- on the compressor.
2. Unscrew the fastening screw -3- at the disconnection point and remove the line from the engine compartment.
Installing compressor/evaporator line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.