911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-419006.png)
2. Check sealing rings of injection valves, if necessary lubricating with silicone spray or similar to ease fitting. Insert fuel distributor pipe together
with fitted injection valves into the appropriate openings of the intake distributor and screw in the fastening screws of the fuel distributor pipe to
the intake distributor -1-. Tighten screws - Tightening torque: 7.5 ftlb.
3. Fit cable holder -2-. Move cable duct into position on the fuel distributor pipe and clip in. Push on cable plug.
4. Fit line connections in left of engine compartment.
4.1. Fit vacuum lines for the brake booster -1-. Press the tandem pump feed line into the holder.
4.2. Connect tank vent line -2-, pressing the rapid-action coupling onto the line (vent line fitted -3-).
5. Fit plastic lines into holder -3 and 4- and fit cable plug onto switch-over valve -1-.
6. Lift engine into position with the car jack and fasten - Tightening torque: 63 ftlb.
