911 Carrera Cabriolet (997) F6-3.6L (2007)
2. Remove cover of console at the left and right.
3. Remove centre console cover.
4. Remove centre console.
5. If installed, remove control unit for tilt sensor.
6. Remove glove compartment.
7. Remove front side section trim.
Preliminary work for head airbag wire harness (head airbag to A-pillar connection point)
1. Remove front side section trim.
2. Remove door trim panel.
Tools and materials
Tools
Commercially available tool for pulling electric wires through.
Installing wire harness for airbag
Installing components for airbag from triggering unit to passenger's airbag unit or seat-belt pretensioner
WARNING:
Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units.
-
Remove ignition key. Disconnect battery. Route or isolate the ground strap so that all contact with a ground carrier (e.g. body, seat
frame) is avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. Release connector on triggering unit for airbag -10- and fold open the locking lever.
2. Remove connector from the relevant component.
2.1. Connectors for stage 1 and stage 2 of passenger's airbag unit -1 and 2-