911 Carrera Cabriolet (997) F6-3.6L (2007)
17. Remove rear underbody cover.
INFORMATION: Only for vehicles with tyre pressure monitoring
18. Remove rear wheel housing liner.
Removing rear wire harness
Exposing rear wire harness
1. Remove left footwell trim panel.
1.1. Remove fuse carrier cover -1- (-arrow A-).
1.2. Unscrew the three fastening screws -2- and take off the footwell trim panel -3- (-arrow B-).
2. Remove right footwell trim panel.
2.1. Partly loosen floor covering -1- at the bottom in the area of the A-pillar -arrow A-.
2.2. Unscrew both plastic nuts -2- and take off the footwell trim panel -3- (-arrow B-).
3. Loosen seat belt mount at left and right.
3.1. Press off cap -1- with a screwdriver and unscrew the fastening screw -2-. Remove seat belt with fitting -3- and spacer sleeve -4-.
4. Disengage floor covering at the support and lay it in the vehicle interior.