911 Carrera Cabriolet (997) F6-3.6L (2007)
NOTE: Make sure that no further work is performed in the area of the seal once the protective film has been removed.
1. Before bonding the windscreen, remove the protective film from the seal such that no residues remain.
Inserting windscreen into the body
CAUTION: Danger of material damage if specified curing time of adhesive is not observed.
-
There will not be a proper adhesive bond if the prescribed curing time of the adhesive is not observed.
-
The vehicle must not be used until the curing time has elapsed.
-
Curing time: 3 hours
-
Temperature: at least 10 °C
-
Fixing time: approx. 1 hour
NOTE:
-
Two persons are needed to insert and adjust the windscreen.
-
The rear window can no longer be aligned, because the bonding section on the seal immediately sticks to the body when the rear window is
installed.
1. Guide the windscreen -5- into the window aperture and insert in the pre-marked positions.
Cleaning fields of vision
NOTE: The door windows must not be closed until after the curing time has elapsed.
1. Adhesive which has oozed out must be removed immediately and the affected fields of vision must be cleaned using cleaning agent -H1-.
Subsequent work
Reworking
1. Install cowl panel cover. Refer to Removing and installing cowl panel cover - removing
2. Connect plug for aerial amplifier. Refer to Removing and installing aerial amplifier
3. Install A-pillar trim. Refer to and installing A-post trim - installing
NOTE: Only with new windscreens
4. Bonding on the interior rearview mirror. Refer to Securing the interior rearview mirror
NOTE: The interior rear-view mirror may only be installed after a curing time of three hours.
5. Installing the interior rearview mirror. Refer to Removing and installing the interior rearview mirror - installing
6. Closing door windows.