911 Carrera Coupe F6-3164cc 3.2L (1984)
Figure 2 Hinge Pillars
Service Information (cont.):
Door Contact Switch for Inside Light Repositioned
During Model Year 1989, hinge pillars were modified. Hinge pillars remain available in both versions.
When installing the new version door on a car with the old version hinge pillar, the door contact switch for the inside light
must be positioned 50 mm further down.
This requires drilling a new hole, 8.4 mm in diameter, 50 mm below the old door contact switch hole (Figure 2). Deburr
edges of the new hole and treat edges with rust prevention paint. Relocate switch into new hole. Install plug Part Number
911 531 999 00 in old hole.
Important:
Instructions for fitting and welding new door shells, printed in 911 Workshop Manual, Model Years 1965-1971, Volume II,
Pages B7 through B13, are still applicable.
Workshop Manual Order Number: WKD 480 520
Parts Information:
Door
Old
New
Right
N/A
911 531 006 23
Left
N/A
911 531 005 23
Hinge Pillar
Right
911 501 040 02
964 502 040 00
Left
911 501 039 02
964 502 039 00
Additionally, the following parts are needed when converting to the new version door