911 Carrera Coupe F6-3164cc 3.2L (1984)
Hole locations to be determined by 600 mm dimension in top photo.
-
check fit of door upper trim covers. Cut out foam on back of trim if necessary
-
mark location of holes for Tenax snaps in trim covers
-
drill 3.5 mm holes in trim covers
-
install trim covers and screw in bottom sections of Tenax snaps (arrows)
-
remove trim caps from instrument panel and screw in bottom sections of Tenax snaps
Installing a new dashboard
-
drill holes for mounting points as indicated above. On left side of panel drill:
^
point A - up to VIN 91 ES17 0540
^
point B - from VIN 91 ES17 0541
-
pull back carpeting from heel plate and shift tunnel at rear
-
cut away insulation and install bracket on center of heel plate to dimension indicated. Fasten bracket with four screws