911 Carrera Coupe F6-3164cc 3.2L (1984)
Interior Moulding / Trim: All Technical Service Bulletins
Tonneau Cover - Available for Service Installation
Group
6
Number
8401
Model
911
Cabriolet
Part Identifier
N/A
December 17, 1984
The optional tonneau cover for the 911 Cabriolet is now available through the Parts Dept. for service installation.
Parts required
Quantity
Part No.
Description
1
911.561.923.00
Tonneau cover
1
911.561.921.00
mounting parts kits
Installation procedure
-
remove trim covers from upper portion of door (screws located under trim caps)
-
mount brackets and holders on doors in approximate positions
-
slide self-tapping nuts onto holders at front of door
-
cut out 60 mm section of door recess seal for clearance at rear bracket mounting
-
drill 3.5 mm holes in tops of brackets for installation of bottom sections of Tenax snaps
Note
Hole locations to be determined by 600 mm dimension in top photo.
-
check to fit of door upper trim covers. Cut out foam on back of trim if necessary
-
mark location of holes for Tenax snaps in trim covers
-
drill 3.5 mm holes in trim covers
-
install trim covers and screw in bottom sections of Tenax snaps
-
remove trim caps from instrument panel and screw in bottom sections of Tenax snaps
-
pull back carpeting from heel plate and shift tunnel at rear
-
cut away insulation and install bracket on center of heel plate to dimension indicated. Fasten bracket with four screws
-
cement carpeting back over heel plate and bracket
-
puncture carpeting at mounting holes
-
install two trim screws in outboard holes and one Tenax snap bottom section in center hole
-
mount Tenax snap bottom sections on side members
-
install tonneau cover to rear of opening on naps (Tonax and standard)
-
stretch cover forward and mark location of existing Tenax snap bottom sections which are directly behind doors on each side
-
cut 9 mm holes in tonneau cover and install upper sections of Tenax snaps (use special key supplied)
-
fasten Tenax snaps at this location