911 Carrera Coupe F6-3164cc 3.2L (1984)
Important:
Tightening sequence must be kept for each step (Picture 4). Bearing surface of the cylinder head bolts and threads must be lightly coated with oil. Never
use lubricants between washer and surface of the cylinder head. Washers must not turn while tightening. Create a reference mark if necessary.
Cylinder Head Gaskets
928S 32 valve engine
Part Number Right side 928 104 367 02 Part Number Left side 928 104 368 02
Cylinder Head Bolts
Part Number 928 101 231 00 - M 12 x 180 Part Number 928 101 233 00 - M 12 x 130
Washers
All engines up to 1986 models
Part Number 928 101 301 02 (25.8 mm dia.)
From 1987 models
Part Number 928 104 229 00 (27.7 mm dia.)
Note:
Hexagon head bolts can also be installed in older engines. Threads in engine block must be cleaned when replacing studs with bolts. Torque angle
tightening method in three steps is also applicable to older engines in conjunction with hexagon head bolts. Hexagon head bolts can be reused in repairs.
New washer, Part Number 928 104 229 00 may not be used on engines before 1987 model year (see sketch).