911 Carrera Coupe F6-3164cc 3.2L (1984)
Figure 2
2. The bumper cover plastic edge should protrude slightly in the bumper cover to fender joint area. If the fender metal
edge protrudes, only the metal edge should be reworked (cut) in the area of the outer mounting screws on the left and
fight side to ensure adequate tire clearance (arrow in Figure 2). After cutting metal, apply rust prevention paint.
Parts Information:
The following parts are required in addition to the tires:
Wheel rim 7J x 17 AH:
Part Number 965 362 124 00
Wheel rim 8J x 17 AH:
Part Number 965 362 126 00
(two each required)
Steering stop:
Part Number 964 347 325 02 (two required)
Rubber valve:
Part Number 900 265 001 50 (four required)
Conversion sets are also available from the Porsche parts department A set consists of:
Four wheels with tires mounted and balanced
Four wheel center hub caps
Two steering stops
Wheel rim cleaner
The following sets are available:
Wheels with Bridgestone Expedia S-01 N0 tires
Part Number 000 043 180 00
Wheels with Pirelli P700-ZN0 tires
Part Number 000 043 180 01
Wheels with Yokohama A-008 P N0 tires
Part Number 000 043 180 02