911 Carrera Coupe F6-3164cc 3.2L (1984)
Differential Case: Service and Repair
Disassembly
-
Drive out input shaft seal in direction of bell housing with an appropriate mandrel.
-
Drive roll pin out.
CAUTION: Mark throwout lever and shaft to ensure proper position when installing.
-
Drive out lever shaft bushings with special tool P 375.
-
Remove bushing.
-
Using a small screwdriver, remove both snap rings from the housing for input shaft and pinion shaft bearings.
NOTE: The retaining rings are pressed against the housing by the bearing outer races. For this reason. first loosen the bearing racer from the snap
rings with a punch.
-
Heat housing to approximately 120°C (250 °F) on a hotplate and drive out both bearing outer races with special tool US 8050.
-
Drive out shift rod needle bearing/bushing from inside of housing using an appropriate mandrel.