911 Carrera Coupe F6-3164cc 3.2L (1984)
Drive Pinion: Service and Repair
Disassembly
-
Press roller bearing off pinion shaft with thrust plate VW 401, disc VW 412, and tube P 255a.
-
Remove components from pinion shaft. needle bearings and races to respective gears to prevent interchanging of parts during reassembly.
Assembly
-
Assemble all pinion shaft parts dry. Make sure that no oil enters between the contact surfaces.
-
Pinion shaft and ring gear are marked with paired numbers. Check that these numbers match before assembling.
-
Press roller bearing on with press punch VW 407 and tube 415a.
-
Install bearing so that the ring of the two part roller cage faces the gears.
-
Press small roller bearing on pinion shaft using thrust disc VW 412 and thrust sleeve VW 244b.