911 Carrera Coupe F6-3164cc 3.2L (1984)
FIGURE 5
The old seal installation tool P381 must be used for the old version tube (40 mm) and P381a only for the new version (50 mm)
FIGURE 6
Since P381a has a guide tube for the oil seal, the guide sleeve should be held in a vise during the seal installation (Fig. 6) and not on a flat surface.
Coordination of Parts
Note:
Before installation of the guide tube/seal into transmission, fill seal between the two lips with chassis grease.
The seal of the guide tube is the same as before, with O-ring, Part #999.701.359.40