911 Carrera Coupe F6-3600cc 3.6L SOHC (1997)
3. Adjust inner shift rod so that all gears can be selected freely without binding.
-
To achieve this, undo hexagon-head bolts of clamping plate and turn eccentric bushing.
4. Screw a long 8 mm bolt into the inner shift rod and shift through all gears to check operation.
5. Place engine-transmission assembly onto general-purpose transmission jack and raise into installation position.
-
Attach transmission support to body
-
Tighten to: 46 Nm (34 ft lb).
NOTE:
-
Check engine compartment rubber seal between body and engine paneling for correct seating.
-
If required, unbolt transmission support from body once more, correct seal position and refit transmission support.
6. Fit shift rod coupling to inner shift rod.
-
Tighten to: 18 Nm (13 ft lb), apply Loctite 270 to threads.
7. Fill transmission with oil, refer to Specifications.
