911 Carrera Coupe F6-3600cc 3.6L SOHC (1997)
1. Mount retaining plate 9282 in vise, fit input shaft and undo hexagon-head nut with Special Tool 9105.
2. Use a suitable tool (e.g. Kukko 17-1) to press all parts off the input shaft over the 2nd gear wheel.
Assembly Notes
1. To inspect synchronizing rings, press rings onto the gear wheel tapers and use a feeler gauge to measure gap "A".
-
Assembly dimension:
New: 0.9 mm minimum
Wear limit: 0.6 to 0.7 mm
NOTE:
-
Transmission shafts without recesses for securing the hexagon nuts have been installed since September 1995.
-
Self-locking hexagon nuts are used on these shafts, and these nuts must always be replaced in every transmission repair.
