911 Carrera Coupe (996) F6-3.6L (2002)
/f6-3.6l/Page-1442003.png)
10
-
Installing seal for the centre joint
-
Insert seal for the centre joint -7- into the module frame in -direction of arrow-. The seal must connect on the left and right so that it is
flush.
11
-
Sticking on Nito tape
-
Stick the Nito tape all the way round the roof module starting from the centering pegs at the front. Refer to "Tools and materials"
12
-
Installing roof module
-
Refer to "Installing roof module"
13
-
Installing cover for sliding roof
1. Refer to "Calibrating spacer sleeves"
2. Refer to "Installing cover for sliding roof"
14
-
Installing electric motor for sun blind
-
Refer to "Installing electric motor for sun blind"
15
-
Installing rear window cover
-
Refer to "Installing rear window cover"
16
-
Setting the microswitch of the sliding roof > closed <
-
Refer to "Setting the microswitch of the sliding roof > closed <"
17
-
Setting closing aid
1. Refer to "Position of closing aid"
2. Refer to "Initialisation of the closing aid"
18
-
Functional inspection
1. Connect the Porsche System Tester to the diagnostic socket. Switch ignition on.
2. Select menu item Targa roof, select menu item actuators, actuate open/close function or actuate rear cover function.
3. Read out fault memory. If necessary, proceed according to; refer to Targa roof diagnosis in the case of an error entry.
19
-
Installing linings
-
Refer to Removing and installing roof lining, front - Targa
-
Refer to Removing and installing roof lining, rear - Targa
-
Refer to Removing and installing passenger compartment monitoring sensor
-
Refer to Removing and installing adjustment fitting
-
Refer to Removing and installing three-point belt, rear - Targa
-
Refer to Removing and installing side-panel lining - Targa
-
Refer to Removing and installing roof member trim
-
Refer to Removing and installing trim of A-, B- and C-pillars - Targa
-
Refer to Removing and installing rear wall lining
Test and adjusting values
Refer to, Diagram - body gap dimensions - Targa
