911 Carrera Coupe (996) F6-3.6L (2002)
If the installation position was not marked during removal or the spacer sleeves are no longer present, it is necessary to calibrate . Refer to "Tools and
materials".
To do so, position all spacer sleeves in the frame for the sliding roof cover and install the sliding roof cover. Check the sliding roof cover according to
the gap dimensions; if necessary re-install or calibrate the spacer sleeves, which vary by 11 - 15 mm.
Replacing the seal for the sliding roof cover
In order to replace the seal for the sliding roof, the sliding roof cover must be removed.
1
-
Removing seal
-
Refer to "Removing cover for sliding roof".
-
Pull off the seal all the way round the sliding roof cover.
2
-
Installing seal
-
Position the seal all the way round the sliding roof cover.
-
Refer to "Installing cover for sliding roof".
Tools and materials