911 Carrera Coupe (996) F6-3.6L (2002)
5. Undo intermediate piece -11- -arrow- (2 M8 nuts and hexagon socket head bolt) and remove in the direction of the battery. Unclip air-conditioning
line -2- from the holder.
6. Remove the bellows -1- on the fire wall and the bellows -2- on the brake booster. Pull off the grommet (rubber groove ring) -3-.
Note! The grommet -3- is not replaced!
7. Undo brake pushrod -9- on the brake pedal and remove.
Note! The former brake pushrod -9- with guide (double rib) -arrow- is to be replaced with the brake pushrod -9.1- without guide!
Fitting
Caution! Material damage to the connection to the brake pedal if the tightening torque used on the connecting pin is too great!
-
It is essential to observe the specified tightening torque on the connection thread bushing/pin!
1. Install new brake pushrod -9.1-. Tighten the threaded bushing -arrow- of the pin to 10 Nm (7.5 ft. lbs.) (Please observe)!
2. Insert seal -7.2- (without lubricant) into the firewall. It is essential to ensure correct seating! Then insert (push in) the connection sleeve -7.1- into