911 Carrera Coupe (996) F6-3.6L (2002)
1
Insert new metal seal
Remove old seal carefully, clean and degrease the sealing surfaces. Insert new metal seal for coolant pump and water guide housing.
2
Mount coolant pump
Put on the coolant pump carefully through the support plate. The impeller and the seal must not be damaged during this procedure.
3
Install coolant pump
Position new seal and coolant pump simultaneously and fasten. Observe the different screw lengths. Tighten screws in diagonally opposite
sequence.
Tightening torque: 10 Nm (7.5 ft. lbs.)