911 Carrera Coupe (996) F6-3.6L (2002)
Tighten chain tensioner cylinder bank 1 - 3 with torque wrench
Tightening torque 80 Nm (59 ftlb.)
6. Fasten coolant pipe (heating), cylinder side 4 - 6, with 2 M6 x 12 hexagon-head bolts.
Tightening torque 10 Nm (7.5 ftlb.)
7. Install chain tensioner, cylinder bank 4-6 -arrow-. Tighten the chain tensioner with a socket wrench insert, hexagon socket a/f 14, with the correct
tightening torque.
Tightening torque 80 Nm (59 ftlb.)
8. Install holder for air-conditioning compressor and servo line. Fasten both holders with 2 M8 hexagon-head bolts and tighten with the correct
tightening torque.
Tightening torque: 23 Nm (17 ftlb.)
9. Pull fixing pin out of the crankshaft belt pulley.
NOTE: Fastening screws for drive plate for the torque converter or the double-mass flywheel must be replaced.
10. Install double-mass flywheel or drive plate for torque converter with new screws. Fit special tool toothed segment No. 9538/1 -Figure- for
countering using an M 12 x 50 screw.