911 Carrera Coupe (996) F6-3.6L (2002)
4. Remove oil temperature sensor. Disconnect electrical connection. Undo and unscrew oil temperature sensor (a/f 22).
Installing oil temperature sensor - GT3
1. Install oil temperature sensor. Fit oil temperature sensor with a new sealing ring and screw in. Tightening torque 25 Nm (19 ft. lbs.). Connect
electrical connection.
2. Install air-conditioning compressor. Push the compressor onto the bracket for the generator again. Screw in the three compressor fastening screws
and tighten to 23 Nm (17 ft. lbs.).
3. Install hydraulic pump. Place the hydraulic pump with connected lines into installation position.
Tighten the three M8 fastening screws to 23 Nm (17 ft. lbs.).
Tighten the M6 screw to 9.7 Nm (7.0 ft. lbs.).
Screw in the two fastening screws on the reservoir and tighten to 23 Nm (17 ft. lbs.).
Tighten the servo pump pulley to 23 Nm (17 ft. lbs.). Fit drive belt.
4. Install air cleaner assembly. Insert air cleaner housing in its holder again. Tighten the M6 x 34 hexagon-head bolt to 9.7 Nm (7.0 ft. lbs.) Tighten
the hose clamp on the throttle body and push the plug onto the hot film mass air flow sensor.