911 Carrera Coupe (996) F6-3.6L (2002)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Removing and installing temperature sensor for coolant - GT3
1. Remove air filter. Unscrew hexagon-head bolt M6 x 34. Undo the hose clamp on the throttle body. Pull off plug from hot film mass air flow sensor
and remove air cleaner assembly.
2. Remove generator. Unscrew B+ wire of battery. Relieve drive belt and remove from the idler pulley. Unscrew the left fastening screw of the
generator. Unscrew the right fastening screw by approximately 1 cm and tap with the hammer until the screw head makes contact again. Then
unscrew the right fastening screw. Lift the generator out.
3. Remove temperature sensor. Disconnect electrical connection and set to one side. Unscrew temperature sensor (a/f 22). Collect emerging coolant
if necessary.
Installing temperature sensor for coolant - GT3