911 Carrera Coupe (996) F6-3.6L (2002)
Seat Belt Tensioner: Service and Repair
Removing and Installing Belt Tensioner
Removing And Installing Belt Tensioner
Installing belt tensioner
NOTE:
-
The belt tensioner may only be installed with the ground terminal of the vehicle battery disconnected.
-
The vehicle battery may only be re-connected after the re-installation of the belt has been completed.
Refer to "Safety regulations for vehicles with airbag and belt tensioner"
1. Install belt tensioner. Observe the direction of travel -3-.
2. Screw fastening screw -B-, tightening torque 50 Nm (37 ftlb.).
3. Insert electrical plug -A- in the belt tensioner.
4. Push in fuse -2- with e.g. a screwdriver in the -direction of travel- until the fuse engages.
5. By gently pulling on the belt -arrow 1-, check the winding ability of the belt strap.
6. Read out the fault memory with the Porsche System Tester.
Refer to "Removing and installing front three-point belt"