911 Carrera Coupe (996) F6-3.6L (2002)
3. Tighten the oxygen sensor with a commercially available open- end ring wrench No. Hazet 4681-1 and 1/2" dynamometric key No. Wille 730
R/12 oder Hazet 6291-1CT with tightening torque.
Tightening torque: 55 + 5 Nm (3.7 ftlb.)
4. Route the black oxygen sensor cable -1- and secure it in the sheetmetal brackets wire retainers, or the cable guide (right side).
Illustration shows cable routing on the right side
5. Connect plug connection (black cable - grey connector) -1- and insert in the holder.
Illustration shows slot in the right-hand side of the engine compartment
6. Install the air filter housing again.