911 Carrera Coupe (996) F6-3.6L (2002)
/f6-3.6l/Page-1118004.png)
9. Pull out spring strut from wheel carrier.
Installation
1. Install in reverse order. Before installing, give the parts a visual check. Replace brake caliper fastening screws.
2. Do not grease screwed connections in Dacromet finish - aluminium colour.
Use correct tightening torques.
3.1 Insert spring strut (A) as tar as it will go into the wheel carrier (B). Before tightening the fastening screw No. 6, twist (align) the spring strut (A)
until the stabilizer block is in the correct position with respect to the wheel carrier (B).
The correct position is described in Point 3.2.
NOTE: As the installation conditions are confined, the correct position (fitting) of these parts is a prerequisite for adequate clearance of the
stabilizer mount in the area of the wheel carrier/stabilizer block.