911 Carrera Coupe (996) F6-3.6L (2002)
-
Replace nut for fastening the piston rod on the spring strut mount.
-
It is recommended to replace the coil springs only in pairs.
NOTE: If the vibration damper is to be replaced, set the height adjusting nut No. 2 to the same position as on the old vibration damper (transfer
the actual dimension A to the new vibration damper).
Special tool 9647
A hook wrench insert - special tool 9647 - is required for this purpose.
Special tool 9647 is required to change the vehicle height (dimension A) and to adjust the stabilizer mating bearing No. 4 - on the front and rear
axles.
The special tool is used together with a torque wrench to tighten the lock nuts (slotted nuts) on the spring struts. Tightening torques under
Suspension, Specifications.
Important: The stabilizer mating bearing (mounting saddle No. 4) need not be adjusted for street use.
Assembly