911 Carrera S (997) F6-3.8L (2005)
Material
Tools
Warning!
Risk of short circuit and fire due to work on vehicle electrical system.
>
When working on the electrical system, the battery must always be disconnected and covered.
>
Always route the electrical wires without tension and so that no chafing occurs, and, secure to existing harnesses/components with
tie-wraps/electrical tape.
Disclaimer
Work Procedure
1.
Preparatory work.
1.1
Remove right wheel housing liner, see Workshop Manual 505619 Removing and installing front wheel housing liner - chapter on
"Removing"
1.2
Loosen activated carbon canister, see Workshop Manual 202519 Removing and installing carbon canister - chapter on "Removing"
1.3
Remove display for PCM operator control unit, see Workshop Manual 911019 Removing and installing display + PCM operator control
unit - chapter on "Removing" or remove "CD player" car radio, see Workshop Manual 912419 Removing and installing "CD player car
radio - chapter on "Removing"
1.4
Remove trim panel under dashboard on the driver's side, see Workshop Manual 701919 Removing and installing trim panel under
dashboard-chapter on "Removing"
1.5
Remove battery, see Workshop Manual 270619 Removing and installing battery - chapter on "Removing"
1.6
Remove cover on right for plenum chamber, see Workshop Manual 852219 Removing and installing cover - chapter on "Removing"
1.7
Punch service grommet in the bulkhead.
2.
Cut-cut opening for antenna base.
2.1
Mask area, Figure 3, item A for antenna hole with masking tape.