911 Carrera S Cabriolet (997) F6-3.8L (2007)
3.2.1 Disengage plug connection => Figure 7 -A- at the body and slide protective hose over plug connection.
3.2.2 Pull locking mechanism and disconnect plug connection (see Step 3.1.2).
4.
Route electric wire harness (=> Figure 2 -C-)
4.1
press rubber sleeves => Figure 8 -A and B- out of A-pillar from the inside and carefully pull these and the door wire harness out through the
openings.
4.2
Press rubber sleeve => Figure 8 -C- out of door and rubber sleeve => Figure 8 -D- out of door and sub-frame and carefully pull these and
the door wire harness out through the openings.
NOTE:
Observe direction of installation of electric wire harness. Open ends of lines (Figure 9 -A-) must be pointing towards the door wire harness
plug connection (Figure 9 -arrow-).
4.3
Guide electric wire harness carefully through the rubber sleeve using a Teflon hose.
4.4
Replace protective hose for door wire harness.