911 Carrera S Cabriolet (997) F6-3.8L (2007)
1.1. Position convertible-top support -1- on the assembly aid and secure with fastening screws -3- or fastening nuts -2-. Tightening torque
Tightening torque: 23 Nm (17 ftlb.)
NOTE: Use assembly grease when fitting the pins.
2. Install roof frame 2.
2.1. Press bushings -1- into the bore on the outside of roof frame 2 -2-.
2.2. Position roof frame 2 -2- on the convertible top support -3- and join them together with the pin -4-. Use the retaining clip -5- to secure the pin
-4-.
NOTE: Use assembly grease when fitting the pins.
3. Install roof frame 3.
3.1. Press bushings -1- into the bore on the inside of roof frame 3 -2-.
3.2. Position roof frame 3 -2- on the convertible top support -3- and join them together with the pin -4-. Use the retaining clip -5- to secure the pin
-4-.
NOTE:
-
When replacing the plastic bushings 1, always replace all plastic bushings.
-
Use assembly grease when fitting the pins.
4. Install roof frame 1.
4.1. Press plastic bushings -1- into the bore on the outside and inside of roof frame 2 -2- and roof frame 3 -3-.