911 Carrera S Cabriolet (997) F6-3.8L (2007)
Tool: Ratchet -1- with long extension.
Removing special screw through additional bore
3.1.
Pull spacer sleeve -2- out towards the right at the top (past the power-steering pump pulley). Press the engine carrier back slightly if necessary.
3.2.
Pull out screw -1- using a bar magnet -2-.
Pulling out screw with a magnet
4. Slide the drive belt (flat side) up past the coolant pump pulley.
Drive belt on coolant pump pulley
5. Turn the drive belt 90 degrees, guide the flat side past the vibration balancer and remove it.