911 Carrera S Cabriolet (997) F6-3.8L (2007)
Valve in cylinder head
3. Replace O-ring -2- and grease with Kluber Syntheso Glep (Part No. 000.043.204.68).
Valve for valve lift adjustment
Installation
Installing valve (for valve lift adjustment)
Information
^
The solenoid hydraulic valve for valve lift adjustment can be fitted on either cylinder bank.
Installation position:
Installation position of valve for valve lift adjustment in cylinder head
1 - Installation position of valve for valve lift adjustment, cylinder bank 1.3
2 - Installation position of valve for valve lift adjustment, cylinder bank 4.6
1. Fit valve with new O-ring at the correct position in the cylinder head.
2. Fit two Torx(R) screws (M5 x 12) and tighten to the prescribed tightening torque.