911 Carrera S Cabriolet (997) F6-3.8L (2007)
2. Engage the condenser on the radiator bracket and secure with the fastening screw -3-. - tightening torque: 4 Nm (ftlb.) (3)
INFORMATION:
-
When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
3. Carefully insert refrigerant lines into the condenser and secure with the fastening screws -2-. - tightening torque: 14 Nm (ftlb.) (10.5)
4. Engage air guide on condenser -A- and screw down using the two fastening screws -1-. - tightening torque: 4 Nm (ftlb.) (3)