porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 3375 > < Procedures|Page 3373
Page 14
background image

Installing compressor-condenser line

INFORMATION:
-

Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.

-

Wet the O-rings of the refrigerant lines with refrigerant oil.

-

Do not open the plugs for the lines and connections until shortly before installation.

1. Carefully insert the line into the engine-compartment disconnection point and fasten with the fastening screw -3-. - Tightening torque: 14 Nm (10.5

ftlb.)

2. Push the line on and fasten it with the fastening screw -2-. - Tightening torque: 21 Nm (16 ftlb.)

Subsequent work

Subsequent work on compressor-condenser line

Screw compressor to engine block.

Install drive belt.

Fill in refrigerant.

Removing and Installing Condenser-Fluid Tank Line

Removing And Installing Condenser-Fluid Tank Line

Technical values

Preliminary work

Preliminary work for line condenser-fluid tank

Procedures|Page 3375 > < Procedures|Page 3373