911 Carrera S Cabriolet (997) F6-3.8L (2007)
/f6-3.8l/Page-120011.png)
Drain refrigerant.
Remove drive belt.
Unscrew compressor from engine block.
Removing compressor/evaporator line
INFORMATION:
-
Close off all lines and connections using suitable plugs during removal.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
1. Unscrew the fastening screw -1- on the compressor.
2. Unscrew the fastening screw -3- at the disconnection point and remove the line from the engine compartment.
