911 Carrera S Cabriolet (997) F6-3.8L (2007)
/f6-3.8l/Page-492003.png)
8. Mark the connection leads to the relevant fuse element.
9. Unscrew the fastening nuts -1-, remove the washer -2- and take out the fuse element -3-.
10. Unscrew fastening nut for the B+ line and remove the power distributor.
Installing power distributor
Installing the current distributor
1. Position the fuse elements -3- in the power distributor in accordance with the wiring diagram and position the marked connection leads in turn, fit
the washer -2- and tighten with the fastening nuts -1-. - Tightening torque: 6 ftlb. - Tightening torque: 11 ftlb.
2. Position the B+ line on the power distributor and tighten with the fastening screws. - Tightening torque: 11 ftlb.
INFORMATION: If a new power distributor needs to be installed or a fuse element replaced, then a new cover for the fuse elements (blue) and a
new seal label (red) must be fitted. The spare parts are summarised in the PET as a package.
3. Insert the blue cover in power distributor and clip in place.
